Herkules
2
Microwave motion detector
for industrial doors
1
Safety instructions
The unit may only be operated from a protection low-voltage
system with electrical separation. The unit may only be opened
and repaired by the supplier.
Never touch any electronic components of the detector
Translation of the original operation instruction
Quality
international
level
EN ISO
9001
Field geometry:
Select whether a narrow or wide field geometry
should be used. The clip must be used for the wide field.
Note:The clip can be used for mounting heights up to max. 4 m.
It is not mounted on delivery. (However, it is stuck onto the rear of the
antenna.)
If the device is already connected, interrupt the power supply for
5 seconds.
After mounting, activate the wide field with the remote control (B+1).
IMPORTANT:
Fit the clip correctly!
Other addresses 5, 6 + 7 can be set using the remote control
(F+8+5…7)
Addressing
: Each detector can be assigned an address (1–4 with DIP
switch and 5–7 with remote control). Different addresses are necessary
when several detectors are within the range of a remote control.
– The detector must be firmly mounted on a flat surface. (Avoid
vibrations)
– Objects such as plants, flags, fans etc. must not protrude into
the detection area.
– The detector must not be obscured by covers/signs
– Fluorescent lamps should not be placed in the immediate
vicinity of the detection area
– Mount the device in the middle above the industrial door
1. Affix drilling jig to wall or ceiling and drill holes according to values
given.
2. Route cable through opening provided in mounting bracket and
make sure length is sufficient for wiring.
3. Screw mounting bracket on tightly
4. Hook detector into mounting bracket and set detector to required
angle. Standard angle: 30°
5. Connect cable according to type plate.
3
Mounting
3.1
Before Mounting
3.2
Mechanical mounting
2
Description of the detector
*
Fa
ct
or
y
se
tt
in
g
55 (2.17")
Ø
5 (
0.2
")
73.5 (2.89")
13
.5
(0
.5
3"
)
Herkules 2
Microwave motion detector
for industrial doors
TOP
TOP
4
5
3
7
6
9
1
2
5
8
13
12
14
15
10
11
Housing
Front cover
Rear wall
Mounting bracket
Fastening
Cover screws
8-pin cable
Microwave planar module
Screw terminal
1
2
3
4
5
6
7
8
Key
Key
Switch addressing
LED red
LED green
Clip
Y
X
9
10
11
12
13
15
14
1
2
3
4
5
Adress 1*
Adress 2
Adress 3
Adress 4
Wall mounting:
Ceiling mounting:
45
125
12
5
50
m
in
.5
0
41
45
12
5
125
50
41
min. 50
Use the drilling jig enclosed
in the packaging!
Page 1
