Operation Manual BioSmart PV-WM v.029.1|03.2021|en
Page 8 of 24
BioSmart PV-WM Reader
Operation Manual
Figure 4
–
Reader board image
Clip connectors description of the reader board is given in Table 3.
Table 3
–
Clip connectors description of the reader board
No
Marking
Description
Purpose
1
GND
Power supply, common wire
Common wire of power supply 12V
2
+12V
Power supply, +12V
«+»
power supply 12V
3
Ethernet
Ethernet connector
with PoE support
Ethernet connector for connection to the
BioSmart UniPass controller
Note - The BioSmart PV-WM reader is intended for use in conjunction with the BioSmart UniPass
controller, which powers the readers through PoE technology, and therefore the GND and +12 V connectors
on the reader are used only as backup power connectors.
The green RUN LED on the reader board during the reader normal operation lights up once every two
seconds for 200 ms.
The jumpers are described in Table 4.
1
2
3
