18
status where the burner operates with 5% (operation capacity can be changed, see Item
5.5) of capacity without fuel supply. Once temperature is dropped up to hysteresis value
from the preset one, «Firing» mode switches on and controller operation repeats.
This mode switches on by setting up the capacity parameter other than «0»
(from «20» to «99»). Start/Stop mode setup menu item is shown on Picture 14.
Picture 14 – Start/Stop Mode Setup
3.4 Date/Time
There is built-in calendar and clock in the Controller. To change date and time it
is required to go to the menu «Date/Time». By turning encoder select menu item
«Service Menu»,
, press the encoder button – code entry window will open (Picture
16). It is required to enter code
1111
, the Controller will go to menu «Date/Time»
(Picture 15).
To change date it is required to move the cursor-frame to date display and press
the encoder button. By turning encoder set up the needed year, and press the button to
confirm. Once the year is confirmed you shall set up a month, if it is required - and
press the encoder button. And after that you set up a date (current date).
To change time it is required to move the cursor-frame to time display and press
the encoder button. First you enter hours, and then minutes.
