SAFETY AND INSTALLATION
SAFETY INSTRUCTIONS - READ
IMPORTANT :
It is important to follow basic safety precautions
when installing and using this electrical equipment,
including the following :
1. Ensure you read and follow all instructions.
2.
WARNING
- Do not allow children to use this
product unless they are closely supervised at all
times. This is to prevent accidental injury.
3. Keep all cables visible and do not bury them.
Also, position them so that they do not get
damaged by lawn mowers, hedge trimmers and
other equipment.
4.
WARNING
- To prevent electrical shock, replace
damaged cords immediately.
5. Read these instructions and keep the instruction
manual in a safe place.
CAUTION
:
Your warranty could become invalid should you fail
to observe the following :
1. The Spa Star must be installed and operated as
«
specified.
2. The life of the unit will be extended (as with most
other pool equipment) if it is placed indoors or in
an enclosed structure.
3. Always power the Eco-Oxidizer from a genuine
Bionizer power adaptor. An incorrect adaptor
could damage the Eco-Oxidizer and will void your
warranty.
CONTROL BOX INSTALLATION
1. Choose a position that will allow you to see the
Spa Star LED readout easily. Fix the control box
«
in position using screws at each corner of the
box. Ensure that the Spa Star is positioned near
«
enough to a power outlet and to the Ionizing and
Oxidizing Pods so the cables reach without
straining.
2. Make sure that the unit is undercover to avoid
UV damage from long term exposure to sunlight.
3. Plug the power adaptor into a suitable power
outlet. The Spa Star should only be powered on
«
when the filtration pump is running. This is best
done by connecting the Spa Star power
«
adaptor into the same power outlet as the pump.
4. Connect the low voltage plug to the Spa Star
«
DC Power Socket (see Page 5). Use only a
genuine Bionizer power adaptor. An incorrect
adaptor could damage your Spa Star and void
«
your warranty.
DO NOT SWITCH THE POWER ON UNTIL
INSTALLATION HAS BEEN COMPLETED.
The Spa Star can be installed onto a new or existing
«
spa or pool with minimal pool preparation. Ensure
that the water is clean and correctly balanced.
See Initial Operation section on page 9.
1. Installing your Spa Star takes around 30
«
minutes.
2. Alternatively engage a competent person to do
the job.
3. If installing it yourself you will need :
!
PVC pressure glue and primer.
!
A fine tooth saw.
!
Philips Screwdriver
!
For masonry walls : hammer drill with 6mm or
1/4" masonry bit.
!
Sandpaper or small file.
SPA STAR INSTALLATION
«
5
TM
