If the Spa Star does not respond to the Remote
«
Control, the most likely cause is that the batteries
need to be replaced.
However, in case there has been some spike or
interference which has caused the Spa Star and the
«
Remote Control to simply not be synced together, we
suggest that you first follow the “Learning a New
Remote Control” procedure below.
If the red LED on the Remote Control does not light
when the button is pressed, then the batteries also
need to be replaced.
REPLACEMENT PROCEDURE
1. Insert your finger or thumb nail into the seam
where the two halves of the enclosure join. Gently
prise the enclosure apart. Do not use a tool, which
could damage the plastic.
2. Slide the two batteries out of the battery holder.
3. Slide two new CR2016 batteries into the battery
holder. Both batteries must have the + side facing
up. DO NOT MIX OLD AND NEW BATTERIES.
4. Press the two halves of the enclosure back
together. Ensure that the seam is even all the way
around.
5. Test the operation of the Remote Control.
If the Red light is lighting when the button is
pressed, but the Spa Star does not respond, then
«
follow the “Learning a New Remote Control”
procedure below.
If the Red light does not light when the button is
pressed, then the Remote Control maybe faulty.
Contact Bionizer or your distributor if this is the
case.
The Spa Star and Remote Control use a rolling code
«
to ensure that other radio devices do not interfere
with the unit. If the Remote Control is replaced at
some time, then it is necessary to follow this
procedure to sync the new Remote Control with your
Spa Star unit.
«
On rare occasions, your Spa Star may lose sync
«
with the Remote Control, so that it does not respond
when you press the Remote Control button. If this
happens, follow this procedure to re-sync your
Remote Control. If it continues to not respond,
replace the batteries as per the procedure above. If
this also fails, then replace the Remote Control.
REMOTE CONTROL LEARNING PROCEDURE
1. Switch the power to the Spa Star OFF.
«
2. Press AND HOLD the One Shot Ionizing button
while switching the power to the Spa Star back
«
ON.
3. The 7 LEDs will be showing a pattern where they
go from Off to 60 around once per second.
4. Press the button on the Remote Control. The LEDs
should go out immediately if the Spa Star and
«
the Remote Control synced OK.
If the LEDs continue the self-learning pattern, then
there is a fault. Contact Bionizer or your
distributor.
REMOTE CONTROL
REPLACING THE REMOTE CONTROL BATTERIES
THE SPA STAR REMOTE CONTROL REQUIRES TWO CR2016 BATTERIES
«
LEARNING A NEW REMOTE CONTROL
IF THE SPA STAR REMOTE CONTROL IS REPLACED, IT MUST BE SYNCED TO THE UNIT
«
14
INSTRUCTION BOOK
