FC1400 User Manual
FC1400OM-2.04 12 / 95
FC1400 Operation Manual
NOTES
Power Requirements
Before connecting the device to the power line, check the voltage and frequency. Ratings of the power
line are the same as those indicated on the unit’s label. If this is not the case, do not connect the
system to the power line until you adjust the unit to match the power source.
In U.S.A, if the installation of this equipment will use 240V rather than 120V, the source must
be a center-tapped, 240V, single-phase circuit.
Restricted Sale
U.S.A federal law restricts this device to sale by or on the order of a physician.
Supervised Use
This equipment is intended for use under the direct supervision of a licensed health care practitioner.
Ventilation Requirements
Set up the device in a location which affords sufficient ventilation. The ventilation openings of the
device must not be obstructed. The ambient conditions specified in the technical specifications must
be ensured at all times.
·Put the monitor in a location where you can easily see the screen and access the operating controls.
-This product is protected against the effects of cardiac defibrillator discharges to ensure proper
recovery, as required by test standards (The screen may blank during a defibrillator discharge but
recovers within a second as required by the test standards).
