26
InnerVue
™
II Diagnostic Scope System
3.1.5.5a Still Capture Mode
Activate the capture for about one (1) second. The light above the Store/Enter
button will blink once and the system will beep. The image that appears on the
InnerVue
™
II display at the time you press this button is the image that will be
captured. It will be saved on the card as a “JPEG (.JPG)” graphics file. The file’s name
will be based on the date & time it was captured (e.g. “MM-DD-YY-HH-MM-SS.JPG”).
When you have finished with this image capture, the InnerVue
™
II Diagnostic Scope
System will return to Still Capture Mode. If you want to immediately review this
image capture, press the Mode button (F5 key) twice to switch to Review Mode. The
image you just captured should appear highlighted in the upper-left corner of the
thumbnail gallery with a “STILL” label.
3.1.5.5b Video Capture Mode
Activate the capture for about three (3) second. The light above the Store/Enter
button will turn on and stay on, and the system will beep. This signifies the
activation of video recording.
The length of this recording depends on the Recording Limit you specified in the
Setup:
If you chose the “10 Second Recording Limit” option, the recording will last (and
the light above the Store/Enter button will remain on) for ten (10) seconds.
If you chose the “No Recording Limit” option, the recording will last (and the light
above the Store/Enter button will remain on) until you press the Store/Enter button
again, or up to the file size limit (i.e. the amount of free space remaining on the
card, or 2 GB total).
Please refer to the Setup section for more information on the Recording Limit
option.
Continue with the video capture, moving the camera as necessary:
Audio is recorded with video-image captures unless disabled in the setup menu.
Speak clearly into the monitor no more than ten (10) feet away from the InnerVue
™
II Diagnostic Scope System’s microphone to have it properly record the audio.
This video recording will be saved on the card as an “Audio-Visual (.AVI)” video
file. The file’s name will be based on the date and time it was captured (e.g. “MM-
DD-YY-HH-MM-SS.AVI”). When you have finished with this image capture, the
InnerVue
™
II Diagnostic Scope System will return to Video Capture Mode.
If you want to immediately review this image capture, press the Mode button (F5
key) twice to switch to Review Mode. The image you just captured should appear
highlighted in the upper-left corner of the thumbnail gallery with a “VIDEO” label.
Press the Store/Enter button (F9 key) to review the entire video file.
Setup and Basic Usage
Summary of Contents for innerVue II
Page 1: ...Operation and Care Manual ...
