FED (E2) 12/2014
page 28/55
6.4.5 Setting the interface mode and, if appropriate, the printer interval
1.
Press down
button for approx. 5 seconds.
The display alternately shows “unit” and the temperature unit:
2.
Press again button
.
The display alternately shows “rASd” and the set-point gradient:
3.
Press again button
.
The display alternately shows “Adr” and the unit address:
4.
Press again button
The display alternately shows “tFCt” and the timer function:
5.
Press again button
The display alternately shows “
PFCt
” and the actual setting of the
interface mode
:
6.
Set the desired interface mode with buttons
.
Settings: Modbus = “0” printer = “1”
In case of temperature data acquisition by the communication software APT-COM™
(option, chap. 8.1) interface mode ”0” (Modbus) must be selected.
The setting is automatically adopted after 2 seconds.
If interface mode “1” (printer) has been selected, the printer interval for the automatic output can be set in
an additional menu step:
7.
Press again button
The display alternately shows “
Prt
” and in the entry level the actual setting of the
printer interval
:
