13
Connector Type- RJ45
• Use a high quality RJ45 connector that matches or exceeds the standard of the cable in use. Shielded
connectors must be used with shielded cables, and must maintain continuity of the shield to both connectors
to protect from interference.
• Snap AV highly discourages the use of
EZ
style, open end RJ45’s with HDMI extenders.
• Always terminate RJ45 connectors in the HDBaseT signal path to the 568B termination standard as required
by HDBaseT standards.
TIA/EIA Standard 568B (Gold Pins Facing Up)
Pin 1
White/Orange Pin 5
White/Blue
Pin 2
Orange
Pin 6
Green
Pin 3
White/Green
Pin 7
White/Brown
Pin 4
Blue
Pin 8
Brown
FIGURE 7: RJ45 Pinout Configuration
6.6.3.2. Installation Instructions
1. Install the Category cable and terminate the ends, then test the cable to ensure operation.
2. Connect the Category cable to the desired HDBaseT output of the matrix switcher.
3. Connect the Category cable to the B-520-RX-230-IR Receiver or the HDBaseT device in use. The Power
over Cable (PoC) feature enables the receiver to be powered via a compatible HDBaseT transmitter, or by
connecting to an optional 12V DC, 2A power supply (B-PS-12VDC-2A).
4. Connect an HDMI cable (2 meters or shorter is recommended) between the HDMI OUT port on the receiver
and the desired HDMI input on the display.
5. Installation is now complete. Test all connected inputs and outputs together to ensure reliable operation.
Note:
For IR Passthrough integration, see section 7.8.
IR Passthrough Installation and Setup
, page 12.
6.7. Matrix Control Connections
All drivers, associated software and extra documentation is available under the
Support
tab on the
B-520-MTRX-230-8x8 / B-520-MTRX-230-6x4+2 product page at www.SnapAV.com
IR IN ALL IR OUT
FIGURE 8: System IR
6.7.1. Matrix Control Connections
The matrix switcher will also process commands received on IR Receiver inputs from B-520-RX-230-IR in zones
connected via HDBaseT. (See Section 7.10.2.
IR Passthrough from Rooms to Sources
on page 15 for an application
example of this feature.)
Note:
System IR control and the front panel IR receiver can be disabled when not in use by using the Configuration
Utility. See the Configuration Utility Manual section,
Other Settings
for more information.
Matrix IR
Control Input
Summary of Contents for B-520-MTRX-230-6x4+2
Page 32: ...Rev 151117 0935 ...
