25
9. FIRMWARE UPDATE
Binary may occasionally release new firmware for the B-520-MTRX-230-8x8 / B-520-MTRX-230-6x4+2 to
address new standards and technology. It will never be necessary to perform an update to an existing, correctly
functioning system, but during installation or service, it is recommended to check the installed version to be sure it
is the newest available.
For full update instructions, see the section titled
Firmware Update
in the Configuration Utility Manual. New
firmware, the Configuration Utility, and the Configuration Utility Manual are available for download on the
Support
tab of the B-520-MTRX-230-8x8 / B-520-MTRX-230-6x4+2 product page at www.SnapAV.com.
10. OPERATION AND CONTROL
During setup and testing, use the included IR remote to control the matrix switcher. After setup is complete, a
control method should have been setup and programmed as described in Section 7.7.
Matrix Control Connections
for
regular operation.
10.1. IR Remote
This section describes the correct button-push sequences to perform regular operations with the IR remote.
The
ENTER
key must be pressed within 10 seconds of the last command in order to be processed.
Key
Function
1
ON
Power on the matrix switcher
2
OFF
Enter standby mode
3
Number Keys
1-9
Select a number
4
10+
Not Used
5
ALL
Select all Inputs or Outputs
6
ENTER*
Enter to trigger the previous setting
7
OUTPUT
Begin output selection
8
INPUT
Begin input selection
9
OUTPUT OFF
Turn off/Mute the selected Output
10
STATUS
Present EDID or Output status
11
LEARN
Learn EDID from one output
12
DEFAULT
Begin Embedded EDID Selection
13
CLEAR
Clear the former IR operation
procedure which user just pressed
but has not yet applied by pressing
ENTER
FIGURE: 18
POWER
1
ON
OFF
2
3
OUTPUT
INPUT
OUTPUT
OFF
STATUS
LEARN
DEFAULT CLEAR
ALL
4
5
6
7
8
10+
ENTER
9
1
2
7
8
9
3
4
11
5
10
6
12
13
Summary of Contents for B-520-MTRX-230-6x4+2
Page 32: ...Rev 151117 0935 ...