Binary B-520-MTRX-230-6x4+2, Instruction Manual, Page: 16 / 32

16
6.9. B-520-RX-230-IR IR Connections
The B-520-RX-230-IR IR ports are described below. Use the diagram for reference.
HDMI OUT
IR
Receiver
IR
Flasher
FIGURE 12
A. IR Flasher–IR output to connect to IR Flasher
B. IR Receiver – IR input to connect to IR Receiver or to output of a control system
6.9.1. Point-to-Point IR Control - Stereo (3.5mm) IR Receiver
When using a powered IR receiver, the DIP switch for IR RCVR PWR should be set to ON. In this case a 3.5mm
(1/8
”
) stereo jack has to be used to send 9V DC power to the receiver.
CAUTION: Do not connect a mono cable to this connection as damage may occur.
1
ON
IR Signal (Tip)
GND (Ring)
9V DC(Sleeve)
FIGURE 13
6.9.2. Control System - Mono (3.5mm) IR Receiver
When using a control system which generates the signal through a mono jack, the IR RCVR PWR switch should be
in the OFF position.
1
ON
IR Signal (Tip)
GND (Sleeve)
FIGURE 14
6.9.3. IR Flasher
IR flashers attached to this port will control equipment using commands sent from a control system flasher output
into the matrix IR Input to Room ports.
FIGURE 15
A B
IR Signal (Tip)
GND (Sleeve)