Bikecomm EZ-02, Installation Manual

Page: 14 / 15

14
Use Your GPS
If you have paired your BikeComm headset with a GPS, you can hear the
voice instruction from the GPS through the headset. If you are on an intercom
with another headset when the GPS voice instruction comes in, you can hear
<dodo> through your BikeComm headset to indicate the incoming GPS
instructions. If you want to listen to the voice instruction from GPS, you can
press [MFB] to end the intercom and the GPS voice instruction will
immediately pass to your BikeComm headset.
During the GPS voice instruction, you cannot activate the intercom. You
must wait until the GPS voice instruction is over before you can activate the
intercom.
Reset to M
anufacturer’s Settings
To reset the BikeComm
headset to the original manufacture’s default
settings with headset off, press [MFB] and [V+] simultaneously for about 7
seconds until the LED turns red. Caution: with this operation, all your previous
settings will be lost.
Quick Reference for Operations
FUNCTION BUTTON
INSTRCUTION
Power ON
Press [MFB] until LED turns blue
Power OFF
Press [MFB] until LED turns red
Pairing
Press [MFB] for 6 seconds until LED flashes red/blue alternatingly
Volume Up Press [V+]
Volume Down Press [V-]
VOX Level Up Press [V+] twice rapidly
VOX Level Down Press [V-] twice rapidly
Set Automatic Answer call Press [V-] for about 7 seconds until LED turns green
Set Voice Answer call Press [V+] for about 7 seconds until LED turns green