Operating manual No.
057-2-6-0005-R0
Version 2018
Page 28
EN
8.4
Cleaning
8.4.1
Initial cleaning
The machine does not require particular initial cleaning, but it is a good practice to clean the
transit areas of the motorcycles by removing the oils and dust to prevent the slip during loading.
Wear water-repellent gloves. Perform the cleaning operations wearing
anti-cut gloves resistant to the substances used (follow the safety data sheet).
WARNING:
Make sure there are no foreign bodies inside the lifting platform and especially
in the sliding guides of the shears and on the rack (6) where the safety bar operates.
ATTENTION
: Any cleaning and maintenance operation must be carried out with the
safety bar inserted.
Keep the operator's work area clean.
The cleaning operations concern:
The machine in general;
The operator's standing areas.
Dispose the liquids and consumables used in the appropriate landfills, according to the legislation
of the Country.
The cleaning of the lifting platform can be carried out by personnel without specific technical skills,
who however know the main characteristics of the machine in order to avoid dangerous
situations.
8.4.2
General cleaning of the machine
Perform the general cleaning of the machine weekly with the utmost care.
Remove foreign substances: you can use non-corrosive detergents for ferrous and rubber material.
These detergents must not be harmful to the operator (follow the instructions contained in the
safety data sheets of the substances used, also for the selection of personal protective equipment
worn by the operator during work).
The use of water jets and flammable liquids is FORBIDDEN.
The use of self-cleaning cloths is recommended.
The support surfaces and locking blocks of the safety bar must be carefully cleaned to remove
traces of oil or grease.