Operating manual No.
057-2-6-0005-R0
Version 2018
Page 22
EN
7
Operation section
7.1
Loading operations
Figure 5
–
general model of a lifting platform
Before installing the vehicle on the platform it is essential to use the wheel lock (Figure 5, [1]), to
check that the work surface (Figure 5, [2]) is
completely lowered
and the ascent ramp (Figure 5,
[3]) is properly positioned.
1-
Load the motorcycle on the work surface [2], by passing it on the ascent ramp [3];
2-
Place the motorcycle on its center kickstand (if it does not have a central kickstand, use one
of our rear kickstand).
Do not lift the motorcycle leaning on the side kickstand;
3-
Tie the motorcycle with the belts (available on request) to make it more stable.
CAUTION:
Never lift the load before making sure it is firmly fastened to the platform with
belts.
Always check during lifting that the load does not slope and unbalance;
During the ascent/descent phase the operator is required to distance from the lifting
platform according to the length allowed by the control panel cable.
Proceed with the lifting operation of the structure according to the following, depending on the
type of lifting available.
Once the working height has been reached, slightly lower the lifting platform in order to make
sure that the safety bar (Figure 5, [4]) is leaning against the stop locks; otherwise, continue the
ascent until the bar exceeds the stop locks located at the base of the lift for the chosen working
height;
ATTENTION
: Do not operate without the safety bar.
If necessary, the ascent ramp can be removed, to allow the operator to work without disturbance
even in the rear part of the motorcycle.
1
4
3
1
