Bike-Lift M516-001, Use And Maintenance Manual

Page: 24 / 50

Operating manual number
057-2-6-0001-R0
Page 24
Version 2021
EN
Installation section
The machine must be installed in compliance with the safety regulations and instructions
included in this chapter.
CAUTION: COMPLETELY remove the wooden sleepers located under the
lifting platform by removing the fixing screws before using the machine.
The machine does not need a basis but requires a flat and horizontal floor. The floor must be
able to support a minimum weight of 500 kg/m
2
.
The motorcycle lifting platform must be placed in such a way as to allow the operator to easily
repair the motorcycles.
The lifting platform must therefore be installed by taking into account the minimum distances
from walls or other possible boundaries (boundaries are imaginary lines which delimit the
work or safety areas of other machines or structures).
The ascent/descent ramp must be positioned so that the bike can be easily lifted. The ramp
must not be directed towards an obstacle which is too close to the motorcycle lifting platform.
CAUTION: It is absolutely forbidden to position the lifting platform on
bumpy or inclined ground.
Bring the machine to the place of installation by using a mechanical lift, unpack it and place it
in the chosen area.
To install the machine, fix it to the floor with 4 dowels M1O x 100 mm, using the appropriate
holes (used to fix the sleepers).
5.1 Power
Foot pump - Connect the hydraulic hose to the nipple on the front side of the pump.
Air pump - Connect the compressed air circuit to the lifting platform.
Electric pump - Connect the electric cable to the power grid using the plug (not supplied),
according to the regulations in force in the Country of use. The socket must be grounded.
TECHNICAL DATA OF THE ELECTRIC MOTOR:
Use voltage: 220/230 V. Frequency: 50 Hz. Absorbed power: 1kW Use voltage:
110/115 V. Frequency: 60Hz. Absorbed power: 1kW