12
The mode is specified in the top left-hand corner of the screen (see blue arrow in Figure 4). To
interchange between ‘Field
Mode’
and ‘Stack
Mode’,
you can either press the top right-hand button
on the joystick (see Figure 3) or press the bottom right button on the screen (see green arrow
in Figure 4).
Figure 4: Screen Display showing the mode.
To enter ‘Road Mode’,
press and hold the top right button on the screen for approximately 2 seconds.
The
‘Entering
Road
Mode’
notice bar will appear at the top of the screen (see Figure 5). To
successfully enter ‘Road
Mode’,
the PTO must be running and the trailer will close up ready to travel
on t
he highway. In the ‘Road
Mode’
sequence, the side gates, rear clamps, guide bar, tines and pickup
may all move to achieve a safe road position.
To le
ave ‘Road Mode’,
the bottom left button must be pressed and held. Again, the bar graphic must
be full befo
re it will return to either ‘Stack
Mode’
or ‘Field
Mode’
(See Figure 6). The trailer will not
automatically move
when removed from ‘Road
Mode’
without input from the operator.
Figure 5: Entering Road Mode
Summary of Contents for Transtacker
