Bibby Sterilin Techne 3Prime, Operator'S Manual

Page: 7 / 56

saFetY InFormatIon
Please read all the information in this manual before using the
3
Prime.
WarnInG
HIGH TEMPERATURES ARE DANGEROUS: they can cause serious burns to operators and ignite combustible
material. Users should be aware of the following potential hazards:
●
USE CARE AND WEAR PROTECTIVE GLOVES TO PROTECT HANDS
●
DO NOT use combustible substances near hot objects
●
DO NOT operate the instrument in the vicinity of inflammable liquids or gases
●
DO NOT place any liquid directly into the instrument.
oPerator saFetY
All operators of Techne equipment must have available the relevant literature needed to ensure their safety. It is
important that only suitably trained personnel operate this equipment, in accordance with the instructions
contained in this manual and with general safety standards and procedures. If the equipment is used in a
manner not specified by Bibby Scientific Ltd. the protection provided by the equipment to the operator may be
impaired.
All Techne instruments are designed to conform to international safety requirements and are fitted with an
over-temperature cut-out. If a safety problem should be encountered, switch off the unit at the mains socket
and remove the plug from the electricity supply.
InstallatIon
The instrument should be carried using both hands. Never move or carry the instrument when in use or
connected to the mains electricity supply.
All Techne instruments are supplied with a power cable; this may be integral or plug-in. 1.
Before connecting the instrument to the mains electricity supply, check the voltage against the 2.
rating plate (located on the back of the unit). Please note that the unit must be earthed to
ensure proper electrical safety . Connect the mains cable to a suitable plug according to the
table below.
connections 220/240V, 50/60Hz 110V/120V, 50/60Hz
Live Brown Black
Neutral Blue White
Earth Green/yellow Green
UK ONLY: The fused plug supplied with the mains cable is fitted with a 5 amp fuse to protect the instrument 3.
and the operator.
The units are rated to operate at 100-240V, 50/60Hz. 4.
Place the unit on a suitable flat bench or in a fume cupboard if required, ensuring that the air inlet vents on 5.
the underside are free from obstruction.
Plug the mains cable into the socket on the back of the instrument. 6.
Switch on the instrument using the switch located on the front of the unit. 7.
replacement cable
Should the mains lead need replacement, a cable of 1mm
2
of harmonized code H05VV-F connected to an
IEC320 plug should be used. IF In DouBt consult a QualIFIeD electrIcIan.
5