Bibby Sterilin Distinction D4000, Assembly And Operating Instructions Manual

Page: 2 / 16

2
Before use
If the equipment is not used in the manner described in this
manual the protection provided by the equipment may be
impaired.
N.B. The Distinction Water Still is classified as “Permanently
Connected Equipment” and should be connected to the
electricity supply by a qualified electrician in the manner
described in the electrical installation section of this manual.
The Distinction Water Still is designed to operate under the
following conditions:
❖
For indoor use only
❖
Ambient temperature range +5°C to +40°C
❖
Altitude up to 2000m
❖
Relative humidity not exceeding 80%
❖
Mains supply voltage fluctuations not greater than
±10% of nominal
❖
Overvoltage category II IEC60364-4-443
❖
Pollution degree 2 IEC664
Limitations of use
This product meets the applicable E.C. harmonised standards for
radio frequency interference and may be expected not to interfere
with, or be affected by other equipment with similar qualifications.
We cannot be sure that other equipment used in its vicinity will meet
these standards and we cannot guarantee that interference will not
occur in practice. Where there is a possibility that injury, damage or
loss might occur if equipment malfunctions due to radio frequency
interference, or for general advice before use, please contact the
Technical Service Department of Bibby Scientific Ltd.
Distinction Water Still
D4000 & D4000/Euro
The Distinction Water Still complies with the
following European Directives:
89/336/EEC - E.M.C. DIRECTIVE
Amended by 92/31/EEC and 93/68/EEC
73/23/EEC - L.V.D. Amended by 93/68/EEC
Figure 1 General assembly
Thermostat reset buttons
Boiler
thermostat
tube
On/Off switch
Clip
Reservoir
level
control
Heater Gaskets
and flange
Distillate
outlet tube
Boiler
Stand
Stopcock
To drain
Constant
level control
Wall mounting
screw holes
Cooling water
inlet
Condenser
thermostat tube
Condenser
outlet
Straps
Condenser
Condenser
thermostat
Boiler
thermostat
Distinction