BH FITNESS Nevada plus G119X, Instructions For Assembly And Use

Page: 31 / 37

31
Fig.1B.-
(41) Leg bar tightening knob.
(42) Leg support adjustment knob.
(43) Leg lock pin.
(44) Weight selector.
(45) Small pulley.
(46) Large pulley.
(47) Upper body cable.
(48) Lower foot pull-up cable.
(49) Butterfly pull cable.
(50) Tube end caps.
(51) Top tube cap.
(52) 45x45 tube cap.
(53) 25 diameter tube cap.
(54) 45 diameter tube cap.
(55) Arm stop protector.
(56) Top bar support protector.
(57) M-12 nut cover.
(58) Arm safety ring.
(59) Bottom stop for weights.
(60) Levelling feet.
(61) Short bar handles.
(62) Long bar handles.
(63) Bottom leg support foam cover.
(64) Top leg support foam cover.
(65) Long foam covers.
(66) Weight post guide cover.
(67) Pulley cable exit cover.
(68) Handgrip strap.
(93) Butterfly bars.
(94) Top spacer for weights.
(95) Top collar for weights.
(97) Leg rotation casing.
(101) Seat support adjustment knob.
Fig.2.- NUTS & BOLTS.
(69) Bolts M-5x10.
(70) Bolts Allen M-8x20.
(71) Bolts M-10x20.
(72) Bolts M-10x15.
(73) Bolts M-10x25.
(74) Bolts M-10x35.
(75) Bolts M-10x50.
(76) Bolts M-10x65.
(77) Bolts M-10x75.
(78) Bolts M-10x95.
(79) Bolts M-10x100.
(80) Bolts M-10x105.
(81) Bolts M-12x75.
(82) Bolts M-12x135.
(83) Flat washers M-5.
(84) Flat washers M-8.
(85) Flat washers M-10.
(86) Washers M-10.
(87) Flat washers M-12.
(88) Flat washers 19x40.
(89) Flat washers 26x40.
(90) Flat washers 13x42.
(91) Self-locking nut M-10.
(92) Self-locking nut M-12.
(100) Bolts M-4x10.
1 .-Place the main frame (4) in
horizontal position (lying flat) on a
table or other level surface Fig.4.
2 .-Place the bases (5-6) onto the main
body (4), as shown in Fig.5, ensuring
the stickers on the left and right match
up, and tighten the screws (78).
3 .-Fit the support leg (3) tightening the
bolts (79) against the rear plate Fig.6.
4 .-Put the screws (79) into the screw
holes so that they are in their correct
position, without tightening Fig.6.
Make sure the main structure (2)
remains in a vertical position Fig.6.
5.- Fit the top body (1) Fig.7 onto the
main body (4). Hand tighten the nuts
(91) as shown in Fig.7.
FITTING THE BUTTERFLY ARM
SUPPORT.-
6.- Fit the butterfly arm support (8) into
the top support (1), Fig.8. Insert bolt
(82), along with washer (87) and nut
(92), and tighten securely. Fit the nut
cap (57).