BH FITNESS Nevada plus G119X, Instructions For Assembly And Use

Page: 32 / 37

32
FITTING THE ARM LIMIT PLATE.-
7.- Take the nuts, washers and bolts
off the arm rotation support Fig.8.
Next, fit the plate (29) with the logo
facing outward and refit the bolts,
washers and nut. Tighten the bolts
securely.
FITTING THE TOP FOAM
COVERS.-
8.- Take the foam covers (65) and fit
them onto the two BUTTERFLY bars,
as shown in Fig.8.
Now take the handle (21), remove the
bolt and the washer Fig.8 and screw it
on to the arms (left and right).
FITTING THE SEAT
STRUCTURE.-
9.- Take the knob from the seat
support (101). Position it on one of the
two seat height setting holes Fig.9 and
secure using the knob (101).
Fit the seat locking pin (39).
FITTING THE HANDGRIP
SUPPORT.-
10.- Fit the handgrip support (11) onto
the tube for the seat frame (102),
Fig.9.
Next, insert bolt (77), flat washer (85)
and tighten using nut (91).
FITTING THE LEG SUPPORT.-
11.- Take the leg support (15) and
insert it inside the seat tube Fig.9, in
the direction of the arrow.
Take the adjustment knob (42) and by
lining up the holes in the two tubes,
turn it clockwise to tighten securely.
Next, fix the protection (97) to the leg
support (15) with screws (100) Fig.9.
FITTING THE SEAT.-
12.- Take the seat (24) and position it
on the seat support Fig.9.
Fit the bolts (91) with their washers
(84) and tighten securely.
FITTING THE BACKREST.-
13.- Take the backrest (25) and
position it against the central mast, as
shown in Fig.10.
Now use the bolts (91) and washers
(84) to secure the backrest Fig.10.
FITTING THE BOTTOM FOAM
COVERS.-
14.- First take the foam covers (64)
and fit them onto the top rounded
tubes for the leg support Fig.10, then
take the end covers (53) and fit them
onto the ends of the rounded tube.
Now do the same for the bottom leg
support foam covers (63).
FITTING THE PANELS.-
15.- Position the left and right
protection plates (26 and 27) onto the
main frame (4), fitting the plate wedge
into the accommodating groove in the
base, then tighten screws (70) slightly
in the upper part as shown in Fig.11.
FITTING THE WEIGHTS.-
16.- Fit the guide post (7) along with
washers (23) and the bottom weight
stops (59) as shown in Fig.12.
17.- Next, place the weights onto the
guide post as shown in Fig.12, in
correct alphabetical order with the
letters facing the front of the machine,
beginning with the letter “L”.