FAULT FINDING CHART
PROBLEM
CHECKS
SOLUTIONS
1.
The monitor does not
switch on.
1) Make sure that the machine is
plugged in, the ON/OFF switch in
position 1 and that the safety key is
inserted.
1) Plug the machine into the mains
supply. Set the switch to position 1
and insert the safety key.
2.
The monitor switches on
but the motor fails to
start.
2) Check that the current limiter is
pressed in.
2) Switch the machine off and press
the circuit breaker in. Lubricate the
treadmill band.
3.
Walking motion is jerky
on the treadmill.
3.a) Check that the belt is
lubricated.
3.b) Check the tension on the
sliding belt.
3.c) Check the tension on the drive
belt.
3.a) Lubricate the sliding belt.
3.b) Adjust the belt tension.
3.c) Adjust the drive belt tension.
4.
The machine stops (the
breaker trips).
4) Check that the band is lubricated. 4) Reset the overload button with
the On /Off switch at „0“ and
lubricate the treadmill band.
5. Electrical
shocks
through the handrail.
5) Check that the machine is
plugged into an earthed mains
socket.
5) Plug the machine into an earthed
mains socket.
6.
The treadmill belt skews
off centre.
6.a) Check that the machine is level
on the floor.
6.b) Check that the machine does
not wobble.
ERROR CODES
Monitor screen displays E1
- Possible motor overload.
- Lubricate the belt.
Monitor screen displays E6-E7
- Elevation fault.
Hesitate to get touch with us if you have any queries, by calling:
902 170 258
8
