BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
INSTALLING NEW BUSH
1. Before installing a new bush, clean the inside of the front control arm housing. Prior to installing
the new bush, ensure that the small arrow embossed on the bush aligns with the front control arm
in the position shown in fig.3. This will ensure correct alignment of the wish-bone on refitting.
2. Assemble the installation (silver) set on the housing as in fig.4. Adaptor (D) is threaded onto the
short threaded end of the force screw (F) with the ridged side facing inwards. Pass the force
screw (F) through the bush, through the front control arm housing and position the Adaptor (E)
over the force screw (F), fitting it against the front control arm housing. Fit the bearing (H) over
the force screw (F), thread on the nut (G) and wind it up to the adaptor (E). Double check to make
sure that everything is aligned and that the bush is sitting squarely against the front control arm
housing.
3. Using a 24mm deep socket or spanner, turn the nut (G) clockwise. The bush will start to be pulled
into the housing. NOTE! If any undue resistance is felt, remove the assembly and check that
everything is correctly aligned.
4. Continue to turn the nut (G) to install the bush, when the bush reaches the adaptor (E), the bush
is fully installed (Fig.5).
5. Disassemble the tool, clean and lubricate before returning the parts to the storage case.
6. Re-fit the wish-bone as per the vehicle manufacturer’s service instructions or a proprietary
manual.
Fig.3
Fig.4
Fig.5
BUSH
BUSH
E
F
G
H
E
D
