BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Page 8
6.2
FLAT COIL
The flat spiral shaped coil is intended for the heating of flat sheet metals and for the straightening of
small dents in car bodies by heating. The flat coil is also intended for easy peeling off of stickers,
sealants, putties etc. by heating of the base material - steel sheet metal.
1. Connect the coil to the coil handle
2. Place the coil with its area over the material
3. Press the button and guide the coil above the material in a gyratory movement
4. After heating of the material, allow the coil to cool off for at least 2 minutes.
NOTE
: It is possible to use the coil to remove various adhesive stickers, sealants and
gaskets which are stuck to sheet metal or metal – for example in automotive, services
etc. The coil is used heating of the base material and thus softening, or alternatively,
hardening of the glue, putty, etc. We recommend holding the coil around 5-15mm far
from the heated material - it is possible to regulate the required temperature and
heating time by changing the distance.
6.3
FLEXIBLE COIL
The flexible coil is used for the loosening of axle fitments, stiffened sensors, ball joints etc. and in
applications where is not possible to use attachable coils.
1. Connect one end of the coil to the coil holder and secure it by the locking screw.
2. Wrap the free end of the conductor over the part which needs to be heated. Make around 2-4
turns.
3. Connect the second - free end of the coil into the coil holder and secure it by the locking screw.
4. Pressing of the key activates the heating.
5. After finishing heating, one end of the coil will be release and the coil will be unwound from the
heated material.
If the overload of the device occurs (the LED warning light on the front panel is flashing red), unwind
one loop and repeat the procedure until the heating is carried out without overload and turning off.
If the heating has a low intensity, on the contrary, try adding one loop.
