position to fully warm up. During this time a slight odour may be
noticed, this is due to the “newness” of the fire and will soon disappear.
f)
Finally, hand the Installation and Maintenance Instructions / Users
Instructions over to the customer and explain the operation of the fire.
3.4
REMOVAL / RE-FITTING OF THE EFFICIENCY BAFFLE
a)
Remove the glass panel as shown in section 2.6
b)
The efficiency baffle if fitted to the inner roof of the combustion chamber
and is secured by 2 off screws.
c)
Remove the screws and pull the efficiency baffle downwards to remove
from the appliance.
d)
Replace in reverse order.
3.5
FITTING THE HANDSET WALL BRACKET
a)
The wall bracket is supplied in the loose items pack and is optional to
fit.
b)
If fitting the wall bracket, please be advised that the thermostatic sensor
is contained within the handset itself, so the position of the wall bracket
will therefore be the position of temperature measurement within the
room. To fit, position as necessary, mark hole positions, drill and secure
with fixings provided.
30
Glass panel
Smoke match position
approximately 5mm
inside canopy at centre
of fire above glass
retaining bracket
Combustion
Chamber
Fig. 41
