Chapter 3. Physical Description
N6603 Installation User Manual
8
Sunshield
: protects the camera lens against direct sunlight.
Bracket
: allows mounting the camera on a surface (e.g. a ceiling, a wall, etc).
Connecting cable
: one end of this cable is plugged into the camera, the other end of this
cable contains the following connectors:
IMPORTANT!
Unscrewing of the connecting cable from the base is PROHIBITED! Non-compliance with this requirement
will void your warranty.
Network connector
: use this port to connect to an Ethernet LAN using an RJ45 connection
(for user’s convenience, an RJ-45 adapter is included with the N6603). Besides, this camera can
be supplied with power over a twisted pair cable (PoE technology) with the use of special
equipment (such as a PoE injector).
Power connector
: connects the camera to 12 V DC 1 A power.
IMPORTANT!
Simultaneous power supply over PoE and power connector is prohibited!
Audio in
: a line in for an external microphone.
Reset button
: when the camera is on, press this button to reboot the camera. Press and
hold this button for at least 10 seconds to reset the camera to factory settings. If a user holds this
button during less than 10 seconds, the camera will reboot without reset to factory settings.
NOTE:
The reset button is covered with a special cap with a hole to protect the button against accidental use.
Slightly push it for activation.
Audio out
: a line out for external speakers (e.g. earphones or speakers with a built-in
amplifier).
Terminal block
: an alarm input and output.
The table below provides a description and specifications of the connectors.
Summary of Contents for N35110
Page 1: ...IR LEDs built in ...
