ASSISTANCE
I
SERVICE
Should you ever require assistance or service contact the BevLes service line, at
(844)265-0250
When
you phone please have the model number and serial number of the unit.. This will assist our service
technicians in providing you immediate assistance. You may want to briefly review the Troubleshooting
Tips before you contact our factory.
TROUBLESHOOTING TIPS
No Power
If your cabinet fails to start when the power is applied via power switch:
1. Check to see if the unit is properly connected to correct power source as specified on the serial
number label.
2. Check to see that your power source (wall receptacle) has power - inspect circuit breaker.
3. Disconnect power cord and visually inspect for any damage.
4. Contact the Bevies Technical Service Department tor assistance.
Excessive Humidity
If your cabinet is producing excessive humidity:
1. Check the setting on the humidity control knob to see if it is set where you normally operate
at.
2. Check the base of the cabinet to see if the excess humidity is draining through the drain hole in
the center of the base.
3. Contact the BevLes Technical Service Department for assistance.
No Humidity
If your cabinet is producing no humidity, or considerably less than normally achieved:
1. Inspect water level in the water pan.
2. Check the humidity control knob to see if it is set where you normally operate at.
3. Check to see if the cabinet door(s) is closed.
4. Make certain that the humidity-heating module's one inch air flow opening (at rear of module) is
behind the cabinet back vent that hangs on the rear wall of the cabinet.
5. Make certain that the polycarbonate water pan cover is correctly positioned over the entire
water pan and the louvers located in front of the water pan.
6. Verify that the fan blower is operating.
7. Contact the BevLes Technical Service Department for assistance.
Excessive Heat
If your cabinet temperature is higher than normal:
1. Check the setting on the temperature control to see if it is set where you normally operate at.
2. Check the ambient room temperature to see if it is greater than your desired proofing
temperature.
3. Contact the BevLes Technical Service Department for assistance.
No Heat
If your cabinet is producing no heat, or considerably less than you normally achieve:
1. Check the setting on the temperature control to see if it is set where you normally operate at.
2. Check to see if the cabinet door(s) is completely closed.
3. Make certain that the humidity-heating module's one inch air-flow opening (at rear of module) is
behind the cabinet back vent that hangs on the rear wall on the cabinet.
4. Verify that the fan blower is operating.
5. Contact the BevLes Technical Service Department for assistance.
