UNPACKING INSTRUCTIONS:
Note:
All Bevies cabinets are tested, inspected and expertly packed
to
insure arrival in
a
ready-to-use
condition. If any damage or loss is discovered when unpacking, ask the carrier's agent (in writing) to inspect
the product. This must be done within
15
days
of
delivery. You can then file
a
formal claim with the carrier.
This product has been shipped securely packed on a wooden pallet, covered with a protective bag and
corrugated shipping container and sealed with durable banding material. Carefully read the following
unpacking instructions and properly dispose of all packaging materials.
To open:
1. Carefully cut and remove banding material.
2. Carefully lift the corrugated container off the product.
3. Remove the protective bag, tear, or tie several knots and appropriately place in a trash
container.
4. Open door(s) and remove the carton containing the universal pan supports, and all packing
materials (tape, cardboard, etc.)
5. Carefully lift cabinet off pallet.
6. Check model number on the serial number label, located on the back of the unit.
7. Release all wheel brakes
SETTING-UP
1. Remove all protective film from interior and, exterior surfaces on cabinet, and doors
2. Open the carton containing the universal pan supports and install all supports in cabinet. Install
the pan supports from the bottom up leaving one extra (unused) slot at the top of each of the four
uprights.
3. Make certain that the polycarbonate water pan cover is properly installed over the cast water
pan and over the louvers in front of the pan.
4. Insert a standard 18” x 26" sheet pan (not provided with proofer) in the slides under the base of
the cabinet. This will serve as a drip pan when cabinet is in use.
5. Place the cabinet in the location where it will be operated. When in position secure the brakes on
the front two wheels. These brakes should always be locked when the cabinet is in use.
6. Make certain that your unit is properly connected to the correct power source as specified on
the serial number label, located on the side of the unit.
