31
Step 3: Switch on the device
• To switch on the EMS circulation stimulator, press the ON/
OFF button on the device or on the remote control. Initially, the
intensity level
00
is set on the left and the right side.
Step 4: Set the usage time
• Use the button on the device or remote control to select the
usage time you want. You can set a usage time of between 5
and 90 minutes (in 5-minute increments).
Step 5: Start electrostimulation / set the intensity level
• Use the +/- buttons on the device or remote control to select the
intensity level you want for the left foot and the right foot. You can
set an intensity level of between 1 and 99. The electrostimulation
starts once you have set the intensity. The remaining usage time
counts down in minutes in the centre of the display.
IMPORTANT
Start with a low intensity level at fi rst so that you
get used to the device gradually.
• If it is hard to feel the electrostimulation, you can moisten the
soles of your feet slightly with water. This provides better con-
duction of the electricity. Do not use cream or lotion; only use
water or a water-based electrode gel.
Note
• During electrostimulation, 15 diff erent pulse wave variations run
in a loop for one minute each. To set one of the pulse wave var-
iations permanently, press the
M
button on the remote control.
If you want the pulse wave variations to be varied again, press
the
M
button again.
Detection for loss of body contact
• If you take your feet off the foot areas of the EMS circulation
stimulator for less than 5 seconds, the device emits three short
beeps. As soon as you put your feet back on the foot areas, the
intensity level that you previously selected is set again.
• If you take your feet off the foot areas of the EMS circulation
stimulator for more than 5 seconds, the intensity level is set to
0
. To continue the stimulation, increase the intensity level again
on the EMS circulation stimulator or on the remote control.
Summary of Contents for FM 250 Vital Legs
Page 143: ...143 ...