Beurer EM 80, Instructions For Use Manual

Page: 30 / 180

30
Note: Setting OFF time to ‘00’ ensures that there is no
period of relaxation between the individual cycles.
• Hold ENTER depressed for approx. 2 seconds to advance to
the treatment time.
Using the UP/DOWN keys, select the desired treatment time
and confirm with ENTER (Fig. 7, Example of 30-minute treat-
ment duration).
• The device is in wait status (Fig. 8).
• Press ON/OFF to start stimulation treatment. Operation
status starts to change and pulse frequence is displayed
alternately with pulse width (Fig. 9).
• Select the pulse intensity which is the most comfortable for
you by pressing keys CH1±, CH2±, CH3±, CH4±.
The pulse intensity display adapts accordingly.
Note: Your individualised programme settings are stored and automati-
cally retrieved when you select it next.
7.4 Changes to the settings
Changing intensity (during application)
• CH1±, CH2±, CH3±, CH4±: Changing the intensity for each channel.
• DOWN key
▼
: the intensity of all channels is reduced.
Interrupting stimulation
Press the ON/OFF button.
If you press it again, the application is resumed.
Switching off a complete channel
Press the CH- key until the channel reaches the lowest intensity, then hold
the key depressed until the channel no longer appears in the display.
Hold down the corresponding key CH+ to reactivate the channel.
Changing application (completely or single parameters)
• ON/OFF: to interrupt stimulation.
• MENU: back to program selection window or main menu.
• Set required parameters. Confirm with ENTER. Press ON/OFF to continue
application.
7.5 Doctor’s Function
Doctor’s Function is a specific setting to allow you to call up your specific
personal programme even more easily.
Your individual programme setting is immediately retrieved in wait status
when you switch on and is activated by simply pressing the ON/OFF key.
Settings for this individual programme may, for example, be on the advice of
your doctor.
With the Doctor’s Function, only pulse intensity can be changed during
stimulation treatment. All other parameters and programmes of the Digital
TENS/EMS are blocked in this case and cannot be modified or called up.
Setting the Doctor’s Function:
• Select your programme and appropriate settings as described under 7.2
or 7.3.
• Before you activate the programme by pressing the ON/OFF key, hold
ON/OFF and keys down simultaneously for approximately 5 seconds.
Storage in Doctor’s Function is confirmed by a long signal tone.
Cancelling Doctor’s Function:
To clear the device again and access other programmes, hold down the two
keys ON/OFF and once again for approximately 5 seconds (not possible
during stimulation). Cancelling of the Doctor’s Function is confirmed by a
long signal tone.
8. Cleaning and storage
Adhesive electrodes:
• In order to ensure that the electrodes adhere for as long as possible, they
should be cleaned carefully with a damp, lint-free cloth.
• After use, stick the electrodes onto the backing film.
Cleaning the unit:
• Remove the batteries from the device every time you clean.
• Clean the unit after use with a soft, slightly moistened cloth. In case of
more extreme soiling you can also moisten the cloth with mild soapy water.
• Ensure that no water penetrates into the device. If this should ever happen,
only use the device again once it is completely dry.
• Do not use any chemical cleaners or abrasive agents for cleaning.
Fig. 7
Fig. 8
Fig. 9