E10
Tire Pressure
Tire pressure should be checked prior to each use of the sprayer and maintained as follows:
320/90R46 Radial Tires
20 PSI
14.9R46 Radial Tires
20 PSI
Keep in mind, that these pressure levels are intended as starting points only. The required
amount of tire pressure may be varied to achieve a 31" footprint when loaded, depending upon the
tank solution (i.e. liquid fertilizer) and field conditions.
Wheel Bearing Replacement
1. Jack tire clear of the ground, block axle securely and remove wheel.
2. Remove hub cap from wheel hub.
3. Remove cotter pin, axle nut and spindle washer.
4. Slide hub from axle spindle, using a hub puller if
necessary.
5. Remove bearing cups from hub and discard.
Thoroughly clean wheel hub and dry.
6. Press in new bearing cups with thickest edges facing in.
7. Pack bearings with heavy-duty wheel bearing grease, thoroughly forcing grease between
roller cone and bearing cage. Also fill the space between the bearing cups in the hub with grease.
8. Place inner bearing in hub and press in new grease seal with lip pointing toward bearing.
9. Clean axle spindle and install hub.
10. Install outer bearing, spindle washer and slotted hex nut. Tighten slotted hex nut while
rotating the hub until there is noticeable drag. This assures that all bearing surfaces are in contact.
Back off slotted nut to nearest locking slot and install cotter pin.
Summary of Contents for Field-Pro IV 1200
