5
Load pool-grade filter sand/Flowclear™ Polysphere.
NOTE:
Use only special pool-grade filter sand, free of all limestone or clay: #20 Silica sand
0.45-0.85mm, approximately one 55kg bag should suffice. If you do not use the recommended size of
filter sand, filtering performance will be reduced and the sand filter may damaged, thereby voiding the
warranty.
NOTE:
To avoid damaging the Skimmer when adding sand, pour some water into the Bottom Tank to
submerse the Skimmer on the Hub.
NOTE: Sand/Flowclear™ Polysphere not included.
NOTE:
Use 28 g (0.06 lbs) Flowclear™ Polysphere to replace 1 kg (2.20 lbs) sand.
Connect to the pool
Assembly
(You will need a screwdriver.)
1.Carefully remove all components from the package and check to ensure
nothing is damaged. If equipment is damaged, immediately notify the retailer
from where the equipment was purchased.
2.The sand filter should be placed on solid, level ground, preferably a
concrete slab. Position the sand filter so the Ports and Control Valve are
acces sible for operation, servicing and winterizing.
3.EN60335-2-41 TEST standard requires the sand filter must be vertically
fixed on ground or a certain pedestal made of wood or concrete before
use to prevent the sand filter from accidental falling. Fully assembled
sand filter will exceed 18kg. The mounting holes should be 8mm in
diameter and spaced 86mm apart. Use two bolts and nuts with a maximum of 8mm in diameter to
fasten the sand filter to the pedestal.
Ф8mm
86mm
1
A
B
A
B
A
B
A
B
MAX.
MIN .
#20
0.45-0.85mm
C
C
C
4
MAX
MIN
