6
7
87
Drywall
Masonry
Minimum 1 1/4 in (32 mm)
Maximum 1 3/4 in (44 mm)
Put the bed back in its place.
Put the CONCRETE SCREWS 3/16 in
(5 mm) diameter X APPROPRIATE
LENGTH into the holes of part #87
and screw the bed onto the masonry
wall until tight against the wall.
Screw must be at least 1 1/4 in (32 mm)
deep into masonry.
USE AN ELECTRIC SCREWDRIVER
WITH AN ADJUSTABLE TENSION
CLUTCH THAT HELPS PREVENT
OVER-TIGHTENING AND STRIPPING.
Using a 5/32 in (4 mm) diameter masonry bit, drill into the drywall
and masonry (a hammer drill is required).
Masonry
Drywall
Wood
Wood
WALL ANCHORING INSTRUCTIONS
INSTALLATION RECOMMENDATIONS — MASONRY
INSTALLATION AND APPROPRIATE HARDWARE
Using appropriate hardware, all the anchor screws of the wall bed must be firmly
secured to the wood or metal studs, the structural components, or a masonry wall.
Only wall anchor screws for wood-frame walls are provided with this bed.
NEVER USE DRYWALL ANCHOR SCREWS OR SECURE THE BED TO DRYWALL
See wall anchoring requirements and installation notes provided in the
instruction manual, according to the type of wall, and use the appropriate
anchors such as described in this manual.
NUMBER OF SCREWS NEEDED
Two (2) screws are required for each anchor point. Three (3) wall anchor points
are necessary for the proper installation of the wall bed. So you need a total
of six (6) wall anchor screws.
THE SCREWS MUST BE VERY WELL ANCHORED TO THE STRUCTURAL
COMPONENTS OF THE WALL.
IMPORTANT WARNINGS
!
5
Move the bed again.
116184 AN
20
SERVICE: 1-888 8BESTAR (1-888 823-7827)
