5
4
2
1
3
WALL ANCHORING INSTRUCTIONS
INSTALLATION RECOMMENDATIONS - WOOD STUDS
Determine the position of the bed in the room.
Locate and mark the positioning
of 3 studs using a stud finder.
Put the bed back in its place. Level by adjusting
the legs PA-844 previously installed. If you install
the bed on a carpet, you must raise the bed by
an extra 3/8 in (10 mm).
Move the bed if necessary, then cut and
remove the floor trim.
Line up plywood part #87 on the wall and mark the middle of the studs on the plywood, then pre-drill
part #87 with 2 pilot holes of 1/8 in (3 mm) diameter per stud, 2 in (50 mm) apart vertically (6 holes in total).
DO NOT DRILL HOLES INTO THE WOOD STUDS.
87
87
2”
(50 mm)
1/8 in
(3 mm)
87
2 in (50 mm)
1/8 in
(3 mm)
PA-844
116184 AN
16
SERVICE: 1-888 8BESTAR (1-888 823-7827)
