Bernini Be42, Manual, Page: 28 / 28

Be42 OEM's Manual V5.0.XX - December - 2010 page 28
28
Section 21.0: Connections description
Terminal Description Note Section
1 Generator Contactor output
300mA Active 'Low'
2.21
2 Mains Contactor output
3
Programmable output „4‟
7.09
4
Programmable output „3‟
5
Programmable output „2‟
6
Programmable output „1‟
7 Fuel Solenoid output 18.0
8 Stop Solenoid output
9 Crank Pilot output
10 Alternator Excitement output Positive Output 3W 11.0
11
Current Transformer „L1‟ S1 input
5Aac nominal; Max 8Aac
7.02B
([P.18])
12
Current Transformer „L1‟ S2 input
13
Generator Voltage‟ Phase L1‟ input
600Vac rated 7.02B
14 Not connected
15
Generator Voltage „Phase L3‟ input
16
Mains Voltage „Phase L3‟ input
7.01A
17 Not connected
18
Mains Voltage „Phase L2‟ input
19 Not connected
20
Mains Voltage‟ Phase L1‟ input
21 Engine Running Minus detect Connect to ground 11.0
22 Engine Running Plus detect D+ or W.L. sensing
23 Supply Battery minus connection - 14.0
24 12 or +24V Battery connection Internal 300mA fuse
25 Common Sender ground sense - 19.0
26 Fuel Level Sender input
2000 Ohm max
7.12
27 Temperature Sender input 7.11
28 Oil Pressure Sender input 7.10
29 Programmable input Switch '4'
Active Low (<2Vdc)
7.07
30 Programmable input Switch '3'
31 Programmable input Switch '2'
32 Programmable input Switch '1'
33 Low Fuel Switch input 18.0
34 High Temperature Switch input
35 Low Oil Pressure Switch input
36 Emergency Stop Switch input
37 RS485 Termination
See RS485 standard See Be42
MODBUS
user manual
38 RS485 Signal A
39 RS485 Signal B
40 RS485 Common Ground
!! W A R N I N G !! Relays and solenoids connected to the Be42 must be suppressed
using flywheel diodes or suppression devices as indicated in section 18.0. We
recommend that you connect a 1A Fuse (fast BLOWING) in series to the terminal #24;
it will protect the controller against large spikes on the power supply.