Be42 OEM's Manual V5.0.XX - December - 2010 page 22
22
Table 13.1: Pushbuttons true table
Pushbutton
Display
Code
Pushbutton
Display
Code
[START-F1]
[ F1 ]
[OFF-F7 ]
[ F7 ]
[STOP-F2]
[ F2 ]
[AUTO
↓]
[auto]
[ I-F3 ]
[ F3 ]
[TEST
↑]
[tESt]
[ O-F4 ]
[ F4 ]
[←F8]
[ F8 ]
[ I-F5 ]
[ F5 ]
[F9
→]
[ F9 ]
[ MAN-F6 ]
[ F6 ]
[ACK-F10]
[ F10]
13.2 Testing the Inputs
Plug the input connector (#29 up to #36). Push and hold the [ACK-F10] button until the message [-in-] appears.
Connect, one by one, inputs #29 to #36 to the battery minus. For each input, a code will be displayed according
to Table 13.2. If more than one inputs are connected together (or some of them in short circuit), the display
indicates the messages in sequence.
Table 13.2
Terminal number
(function)
Display
Code
Terminal number
(function)
Display
Code
#29 (Input 4)
[ inP 4]
#33 (Low fuel)
[ FUEL]
#30 (Input 3)
[ inP 3]
#34 (Temperature)
[ tEMP]
#31 (Input 2)
[ inP 2]
#35 (Oil pressure)
[ oiL]
#32 (Input 1)
[ inP 1]
#36 (Emergency)
[ EMEr]
13.3 Testing the Outputs
A) -
Push the [ACK-F10] pushbutton, for about 10 seconds, until the message [-out] appears.
B) -
Plug the output connector (terminal #1 - #10), as indicated in the section 13.1. At this stage, if a lamp turns
on, the Be42 is damaged and should be returned for service.
C) -
Push a button on the front panel. According to
Table 13.3
, the display should indicate the proper message
and the lamp turns on. If a lamp fails to turn on, the Be42 is damaged and should be returned for service.
Table 13.3: Outputs true table
Pushbutton
Display
Code
Terminal
Output
Pushbutton
Display
Code
Terminal
Output
[START-F1]
[KG]
# 1
[OFF-F7]
[FUEL]
# 7
[STOP-F2]
[KM]
# 2
[DISPLAY-F8]
[StoP]
# 8
[I-F3]
[out 4]
# 3
[DISPLAY-F9]
[StAr]
# 9
[O-F4]
[out 3]
# 4
[AUTO]
none
[I-F5]
[out 2]
# 5
[TEST]
[MAN-F6]
[out 1]
# 6
[ACK-F10]
To exit the Troubleshooting, remove the Vdc supply at anytime