Remember if you need help contact Customer Care: 1+ (619) 449-2392
|17
Place the shim underneath the base
on the opposite side that is not flow-
ing as strongly as the other sides.
Grasp the shim and break it on the
crease closest to the end of the
base.
Once the shim is broken, it will be
hidden but will level your fountain.
Before beginning, remove
the Battery Assembly
from Torri Topper.
Step 1:
Lift the Battery
Assembly out of the Torri
Topper to access pump
and tube.
Step 1:
Rest the Battery
and Pump Assembly on its
side. Check the connection
at the top of the water tube
at the Battery Housing. Re
connect if needed.
Step 2:
Check the
connection at the bottom
of the water tube at the
Water Pump. Re connect if
needed.
Step 3:
Reassemble the
Battery and Pump Assembly
in reverse of removal or refer
to the instructions in the
Battery and Pump Assembly
section of this manual.
If you find the Water Pump is running, but water is not flowing from your Fountain, you can try
priming the Water Pump:
Turn off Fountain, grab both sides of the Fountain and quickly shake your Fountain for ten seconds.
This is to dislodge any air bubbles that may be caught in your Water Pump. Press the button to
turn your Fountain on.
Water should be flowing from the top of your Fountain. If water is not flowing, press and hold
button for over 2 seconds again to turn your Fountain off, and repeat the step above.
Priming The Water Pump
Water Pump Connection
If your fountains water pump becomes disconnected use these instructions to reconnect your water pump.
Using Leveling Shims
If you are having trouble getting water to flow evenly off of the edge of your fountain, you may need
to level the surface that your fountain is placed on. With the included leveling shims, you do not
need to move your fountain, just follow the instructions below to get even water flow.
