Remember if you need help contact Customer Care: 1+ (619) 449-2392
6|
Figure 1b
Figure 1c
Figure 1a
Battery Compartment Retaining
Screws X2
Installing Batteries:
1. (If Battery Compartment & Water Pump are installed into the Topper) Lift out of the Topper (Figure 1a).
Disconnect the Water Tube from the Battery Compartment (A Figure 3a).
2. Unscrew (counter clockwise) the Battery Compartment Screws, screws DO NOT come out of the battery
compartment, when the screw continues to spin or you hear a click the screw is unscrewed completely, slip
pump cable out of cable notch, and open cover (Figure 1b & 1c). Note: Cover fits tightly, may take some strength
to pull apart
3. Fountain requires 4 D batteries (Not Included), insert x2 D Batteries with the (-, Negative) side facing down
in Battery Compartment (Figure 2a),, negative side of the battery will be resting on the raised coil/spring. Then
insert the other 2x D Batteries with the (+, Positive) side facing down in the Battery Compartment. (Figure 2a).
4. Reinstall the Fountain Top by aligning the locating dowel in the Battery Compartment and Fountain Top. Set
the Battery Cover down onto the Battery Compartment ensuring the dowel sets into the alignment hole and
that the pump wire is placed back in the cable notch. Apply pressure and tighten the Battery Cover Screws by
turning clockwise. NOTE: Pressure must be applied to the Battery Compartment while tightening the screws to
assure the compartment is properly sealed. If needed, while holding battery compartment, place it upside down
on an even surface to tighten screws (Figure 2a, 2b & 2c).
Figure 2a
Figure 2b
Locating Dowel
Battery Cover
O-Rings
Figure 2c
Inserting Batteries Into The Battery Compartment
