UM - CODE N1 N2 N3 N9 - REV 0.3
34
8. Locating and eliminating failures
PROBLEM
PROBABLE CAUSE
CURE
Pressing the start button the macìhine does not
start.
No electricity.
Check that the plug is correctly inserted.
Pressing the start button the machine starts but the
working light does not come on.
Light is detective.
Do not use the machine if the light does not work.
Contact service for assistance.
The machine starts but the motor heats up too
much, it gives off a bad odour.
Defective motor.
Do not use the machine.
Contact service fort assistance.
The machine vibrates.
The blade is not sharp.
Contact service for assistance.
Excessive resistance in cutting the product.
The blade is not sharp.
Sharpen the blade.
The blade slows or stops under stress.
Loose belt.
Contact service for assistance.
Sharpening is no longer regular.
Grindstones are excessively dirty.
Clean the grindstones.
Grindstones worn out.
Replace the grindstones; contact service for assi-
stance.
The blade is not sharp.
Sharpen the blade.
The blade is excessively used
Replace the blade.
Contact service for assistance.
The machine does not stop when the stop button is
pressed.
Control circuit is defective.
Pull out the plug to stop the machine and immedia-
tely contact service for assistance.
The sliced product is frayed and irregular
WARNING: In this chapter the most common problems caused while using the slicing machine are listed together with the necessary operations to
eliminate the possible causes. If the problem persists ask for assistance from a qualified person authorized by the maker, do not insist on looking for the
cause.
