UM - CODE N1 N2 N3 N9 - REV 0.3
28
Cleaning the sharpener
1. Clean the body with a damp cloth and the
grindstones with a semi-rigid nylon brush;
2. Don’t immerse sharpener.
Cleaning the components in the base
The components contained in the base do not need
any special cleaning; occasionally remove the dust
that can accumulate in the end area of the carriage
and of the thickness plate regulation.
6.2.4. Knife removing tool instructions
If your machine is supplied with a knife remover
please proceed as follows:
WARNING: Cutting danger! Act with attention and
concentrate on the job.
- Disconnect the machine from the electric mains
supply;
- Remove the blade cover unscrewing completely
(counterclockwise) the tension rod knob (see
6.2.2)
-
Ensure the slide deflector is removed before fitting
the knife remouver;
- Fit the knife remover (1) as in the drawing and
insert the external edge of the ring with attention,
under the ring (2);
- Adjust the knife remover correctly (1) and screw
the knurled knobs completely in to the threaded
holes of the knife (3);
- Loosen and remove the screws (4) fixing the blade
to the pulley shaft;
- Pull off the knife remover with the blade always
using the knurled knobs (3);
- Proceed to an accurate cleaning of the machine,
as described in section 6.2.3, and of the rear of
blade from the centre outwards and allow to dry;
- Now you can place the blade still fitted on the
knife remover back on to the slicer following the
above procedure, in reverse.
WARNING: after removing the knife removing tool
check each of the blade fixing screws to make sure
they are tight.
1
2
3
3
4
1
