Beretta IDRA MS 200, Installation And Operation Manual

Page: 11 / 16

11
INSTALLER
10 UNPACKING THE PRODUCT
B IDRA MS storage cylinders are delivered in a single
package, protected by a cardboard box on a wooden
pallet.
The following items are delivered in a plastic bag inside the
packaging:
- Instruction manual
- Spare parts catalogue
- Hydraulic test certificate.
A
B
H
MODEL A B H
Weight
(Kg)
200 700 700 1480 85
300 700 700 1980 115
430 850 850 1790 150
550 850 850 2130 165
11 HANDLING
Make sure that any lifting equipment is of adequate
capacity to lift and move the storage cylinder. Remove the
brackets (1) to free the storage cylinder.
To lift the storage cylinder, remove the plug (2) and
insulation (3) and screw an eyebolt (Ø 10 mm) of suitable
capacity for the weight of the cylinder into the hole (4).
1
1
1
2
4
3
If suitable equipment is not on hand to lift the storage
cylinder off the pallet using the eyebolt, proceed as follows.
- Place a platform of about half the height of the pallet
near the storage cylinder. Make sure the platform is
able to support the weight of the storage cylinder
- Remove the brackets (1) then carefully rotate and
slide the storage cylinder off the pallet on to the
platform
- Make sure that the storage cylinder is perfectly
stable, and then remove the pallet
- Carefully rotate and slide the storage cylinder off the
platform on to the floor
- Remove the platform. Position the storage cylinder as
required.
Adjust the feet to ensure that the storage cylinder is
perfectly level.
17
b
Wear suitable personal protective equipment and use
suitable safety devices.
a
Do not dispose of packaging material into the
environment, or leave it within the reach of children,
since it can become a potential hazard. Dispose of
packaging material in compliance with applicable
legislation.
Installer