Beretta IDRA DS 1000, Installation And User Manual

Page: 14 / 24

14
INSTALLER
11 Handling
MODELS IDRA DS 200 to 550
Make sure that any lifting equipment is of adequate capa-
city to lift and move the storage cylinder.
Remove the brackets (1) to remove the storage cylinder
from the pallet.
To lift the storage cylinder, remove the plug (2) and insula-
tion (3) and screw an eyebolt (Ø ¾”) of suitable capacity for
the weight of the cylinder into the hole (4).
1
1
1
2
3
4
If suitable equipment is not on hand to lift the storage cylin-
der off the pallet using the eyebolt, proceed as follows.
- Place a platform of about half the height of the pallet near
the storage cylinder. Make sure the platform is able to
support the weight of the storage cylinder.
- Remove the brackets (1) then carefully rotate and slide
the storage cylinder off the pallet on to the platform.
- Make sure that the storage cylinder is perfectly stable,
and then remove the pallet.
- Carefully rotate and slide the storage cylinder off the pla-
tform on to the floor.
- Remove the platform. Position the storage cylinder as
required.
Adjust the feet to ensure that the storage cylinder is per-
fectly level.
17
b
Wear suitable personal protective equipment and use
suitable safety devices.
a
Do not dispose of packaging material into the envi-
ronment, or leave it within the reach of children, since
it can become a potential hazard. Dispose of packa-
ging material in compliance with applicable legisla-
tion.
MODELS IDRA DS 750 to 1000
Make sure that any lifting equipment is of adequate capa-
city to lift and move the storage cylinder.
Remove the brackets (1) to remove the storage cylinder
from the pallet.
To lift the storage cylinder, remove the plug (2), insulation
(3) and magnesium anode (4) and screw an eyebolt (Ø 1
¼”) of suitable capacity for the weight of the cylinder into
the hole (5).
1
1
2
3
4
5
1