Beretta 20141085, Installation Manual, Page: 57 / 112

57
3 COMMISSIONING AND MAINTENANCE
3.1 Initial startup
- Switch the system's master switch to the ON position and the
thermal module's master switch to ( I ).
3.1.1 Switching the appliance on and off
After switching the appliance on, the display shall look as shown in
the figure below:
04:29
12.0
”
°C
”
“
CH Setpoint
”
48.0
”
°C
”
External temperature is shown on the display on the left. This value
is displayed only if the outdoor temperature sensor (accessory) is
installed.
Main setpoint values are shown in the lower side of the display while
the time is shown on the top right side.
To turn the equipment off set the main switch “0/I” that is placed on
the back side to “0”.
b
Never power off the appliance before switching the master
switch to the "0" position.
b
Never switch off the appliance with the master switch if a
request is active. Always make sure that the appliance is in
stand-by before switching the main switch.
3.1.2 Date and time setting
Press the MENU key and select "Settings" with the
▲
/
▼
keys
“
Menu
”
“
Central Heating (CH)
”
“
Information
”
“
Settings
”
“
System Test
”
Confirm with the
●
key and select "General settings" with the
▲
/
▼
keys
“
Settings
”
“
General Settings
”
“
Boiler Settings
”
Confirm with the
●
key and select "Date and Time " with the
▲
/
▼
keys
“
General Settings
”
“
Language
”
“
Unit Type
”
“
Date & Time
”
“
Cascade mode
”
Press the
●
key, the display will be shown as follows:
“
Date & Time
”
“
Date:
”
“ Sunday ” 10/25/2015
“
Time:
”
03:02
“
Time Zone Settings
”
“
Display Settings
”
Press the
●
key to highlight the values.
“
Date & Time
”
“
Date:
”
“
Sunday
”
10 /25/2015
“
Time:
”
03:02
“
Time Zone Settings
”
“
Display Settings
”
Values can be changed with the
▲
/
▼
keys.
Confirm the value entered pressing the
●
key and move to the next
value.
“
Date & Time
”
“
Date:
”
“
Sunday
”
10/ 25 /2015
“
Time:
”
03:02
“
Time Zone Settings
”
“
Display Settings
”
To set the time, follow the same procedure.
By accessing the "Time Zone Setttings" menu, it is possible to set the
time zone parameter as shown in the figure below:
“
Time Zone Settings
”
“
Time Zone Correction
”
UTC +00.00
“
Daylight Savings Time
” “
Disabled
”
To change the way in which date and time are displayed, it is possi-
ble to change the following characteristics by accessing the "Display
Settings" menu:
“
Display Settings
”
“
Time Notation
” “
24h
”
“
Date Order
” “
DMY
”
“
Day Of Month
” “
2Digits
”
“
Month
” “
2Digits
”