Hook-up and un-hook accessory
12
(Method #2 : subframe with accessory
already installed):
A.
Install the rear hitch (item 1) in the vehicle hitch
(item 2) and hold in place with the pin (item 3) and
the hair pin (item 4) supplied with the vehicle.
B.
Drive the vehicle over the subframe. Align the front
subframe (item 3) under the hitch brackets (item 4).
IMPORTANT
: The clearance distance from the
ground may vary depending on the accessories
installed on the vehicle. If there is not enough
distance between the vehicle and the ground, slide
the subframe by hand under the vehicle.
C.
Stop the vehicle,
see the vehicle shut-down
procedure for stopping the vehicle in the operation
section
.
D.
Connect the hydraulic hoses (item 1) to the vehicle.
Make sure the excess hoses are on the subframe to
allow the subframe to move. See subsection
"installation of hydraulic hoses" in the section "hook
and un-hook accessory".
E.
Start the vehicle engine and lower the lift arms (item
2) (the snowblower is hidden in the image) so that the
subframe is mounted inside the hitch brackets as
illustrated.
F.
Stop the vehicle,
see the procedure for stopping the
vehicle in the operation section
.
G.
Secure the front subframe in place with the pin (item
4) and the lynch pin (item 5).
H.
Start the vehicle engine, raise the accessory, this
raises the rear of the subframe.
I.
Stop the vehicle,
see the vehicle shut-down
procedure for stopping the vehicle in the operation
section
.
J.
Secure the subframe (item 1) to the vehicle with the
pin (item 2) and secure in place using the lynch pin
(item 3).
O.
Unite the driveline shaft to the mid P.T.O. with the
quick attach (item 1).