Bercomac 700580-4, Owner'S Manual

Page: 21 / 100

18
ASSEMBLY
6. In the case the winch is not strong enough to lift
the snowblower or if the top of the pulley is higher
than the winch, it is possible to install the lift
system as follows:
Attach the lift strap (optional) (item 1) to a well
anchored part of the vehicle. Secure the winch
hook (item 2) in the lift strap. Place the winch
cable around the pulley (item 3) . Secure the pulley
in place with a pin (item 4) and a hair pin (item 5) .
Lift system
IMPORTANT : WINCH MAXIMUM LOAD
Some winches are very powerful. Using these
winches could cause breakage in the sub
-
frame. This
is caused by the operator continues to operate the
winch when the blower comes into contact with the
sub
-
frame during lifting. In addition, the angle at
which arrives winch and the amount of cable on the
winch, also have an influence .
We recommend:
•
Stop the winch as soon as contact is made
between the blower and the chassis
•
To buy and install the lift limit switch #700849

If your winch is a capacity greater than
2500lbs

If capacity is lower than 2500lbs, but you find
that the winch tries to twist the sub
-
frame
IMPORTANT: Make sure that the winch cable
(item 1) does not pull downwards to prevent
damages of the engine support and the pivoting
wheels.
1 2
5
3
4
1
1
VERIFYING THE ASSEMBLY
THE LENGTH OF THE SUBFRAME
When the vehicle is advancing in a straight line,
make sure the wheels of the subframe do not come
into contact with the wheels of the vehicle.
When the snowblower is raised to its maximum,
make sure the snowblower engine does not come
into contact with the vehicle.
PRESSURE OF THE TIRES ON THE
SUBFRAME
Verify and adjust the pressure of the tires of the
subframe at 50 psi.
The tire pressure must be even on both sides.
Wire assembly
7. Plug the electrical wiring of the snowblower.