Installing the device
31
¾
Lift the device from below into the base plate with
the installation cut-out using two persons.
¾
Insert one Phillips screw M8 x 30 mm with a
corresponding washer per mounting into the
mounting hole from below.
¾
Screw the Phillips screws in approx. five turns.
The device hangs loosely on the two screws.
The device is pulled upwards into its final
installation position using the two screws.
¾
Screw the Phillips screws in in turn until the upper
edge of the device contacts the lower edge of the
installation cut-out.
¾
Make sure that the device is positioned to the
correct dimensions. The final installation position
can still be corrected minimally by applying
pressure with the hands.
¾
Make sure that the device is securely screwed to
the two mountings.
¾
Tighten the Phillips screws.
