Safety instructions for the installer
Safety
9
In recirculated air mode:
§
A covered or sealed ventilation outlet can cause a
fire hazard. In the case of recirculated air devices,
out flowing air must be able to escape back into the
kitchen through the ventilation slits without
impediment.
§
You may not install any objects that could impede
the airflow. Make sure that out flowing air is able to
flow into the kitchen without impediment.
The device may only be installed over a fireplace for
solid fuels (e.g. a coal-burning stove) if:
§
the fireplace has a sealed cover which cannot be
removed. Otherwise there is an increased fire risk
due to flying sparks.
§
the legal and country-specific regulations are
observed.
Avoiding risks of injury
§
To prevent the risk of falling, use a stable step-
ladder for all work on the device, for example
replacing the filter, installing and cleaning the
device.
§
To prevent injury from falling parts, only use
suitable fastening materials.
§
To prevent cuts from broken glass, use suitable
protective gloves.
Avoiding the risk of suffocation
§
Never let children play with the foil or other parts of
the packaging.
§
Store the film or other parts of the packaging in a
location which is inaccessible to children.
§
Make sure that all standards and guidelines for
operating the device in your country are observed.
In extracted air mode:
If the device and an open fireplace which uses air from
the room for its oxygen supply are used at the same
time, gases or waste gases may be drawn into the
room.
§
Make sure that all safety equipment required by the
regulations in force in your country are working
properly (e.g. the under-pressure monitor P4
checked in accordance with DVGW-VP121 and in
accordance with DIN 18841:2005-12 TÜV).
§
Make sure that all of the permits required for
operation in your country have been obtained (e.g.
the master chimney sweep).
§
Make sure that all standards and guidelines for
operating the device in your country are observed.
§
Ensure there is an adequate supply of fresh air into
the dwelling.
Minimising the danger of collapse
In extracted air mode:
§
The wall breakthrough that is needed must be
created by technically qualified persons. Wall
breakthroughs affect the building's structural
stability. Improperly made wall breakthroughs could
result in the building collapsing.
