Installing the device
50
Installation instructions
Hang the device
DANGER
Danger from falling parts if improperly
fastened.
Ø
The supplied fastening material is
only to be used for installation into
an installation cut-out in a bearing
and stable wooden cabinet (e.g.
cabinet body).
Ø
Make sure that the bearing capacity
is sufficient and use appropriate
fastening material.
For this step you do not require any tools.
Ø
Ensure that both levers are pre-tensioned and
slanted downwards.
Ø
With two persons, lift the device from underneath into
the base panel with the installation cut-out.
In the end position, the levers engage automatically
and hold the device.
Ø
Push the device upwards until both levers engage.
Ø
Ensure that both levers have engaged.
Align the device horizontally
For this step you do not require any tools.
You can slightly adjust the alignment of the device.
Proceed as follows:
Ø
Push the device into the desired position by pushing
against the device on the side with your hand.
Fixing and securing the device
For this work-step, you need a Phillips screwdriver.
The device is screwed from below using two cross-
head screws and connected to the brackets.
Proceed as follows to secure the device after the
installation.
Ø
Ensure that the device is fixed to the brackets from
underneath each with one cross-head screw.
Ø
Ensure that the device is secured.