General description
The OmniaMOD-V2 central station receives events from remote security sys-
tems. A remote security system consists of a control panel with built-in digital
communicator. Data from the control panel is sent via telephone to the Om-
niaMOD-V2 modem, which then sends it to the computer. Event data that is
received by the modem is interpreted by the Central Station software, accord-
ing to the client data:
Ø
client address;
Ø
telephone number;
Ø
system pictures and ground plans;
Ø
sensor position on the premises;
Ø
diagram of arm/disarm times of the remote security system.
Each event which occurs in the remote system causes the communicator
to send coded data to the OmniaMOD-V2. When the event is acknow-
ledged, it is displayed on the monitor (and also printed on the printer) ac-
cording to its priority. Events are classified in three groups:
Ø
alarms
(an event is acknowledged by an acoustic signal and flashing of
the message in the active window);
Ø
warnings
(also generate the acoustic signal and message in the active
window);
Ø
messages
give the rest of the information which tells the operator of the
status of the remote systems, and of the Central Station itself (arm/disarm,
test communications, operator change-over, ...).
When an alarm or warning occurs, the operator, according to instructions, scans
the system information and pictures, then takes the necessary actions to elimi-
nate the cause of the event (calls the fire brigade, sends a security team to the
system location, sends maintenance service to the system location).
System requirements and description
Computer
r
CPU i80486 or higher.
r
4Mb of RAM.
r
At least 10 Mb free on the hard disk.
r
MS-DOS 3.3 or higher
r
Printer.
Telephone lines
Public telephone network or local telephone network with equivalent char-
acteristics.
Modem
BENTEL OmniaMOD-V2.
remote security
system
Built-in communicator with the capability of sending data in ADEMCO pro-
tocol 10 baud in required data format 3+1, 3+2, 4+1, 4+2.
6
Central Station
OmniaMOD-V2