Modem
The B-Mod or B-Mod-RX modem will allow you to communicate with Fireclass
Control panels from a remote location. Access to this function requires entry of
the Installer PIN code and User authorization (i.e. the user must enable the
Teleservice
function). For details regarding the
Teleservice
function, refer to
Telecom Module under Modifying in the "Installation Manual".
1
. Using the serial cable, connect the Modem to one of the PC serial ports.
2
. From the
Main
menu of the software application:
Settings
>
System Settings
>
Remote Communication
>
Serial Ports
then
---- set up the serial port parameters (refer to
Parameter Settings
see also
Settings
window Fig. 6);
---- click-on
OK
.
The
Modem
menu provides the
Remote Communication
and
On hook
options.
Remote
Communication
3
. Select
Remote Communication
to open the respective window (see Figure 10).
4
. Program the respective parameters, as follows:
Telephone number
---- type in the Control panel telephone number;
Disable Tone check
---- if this option is enabled, the modem
WILL NOT
CHECK
the line for the dialling tone before dialling;
Bypass answering devices
---- if this option is enabled, the control panel will over-
ride any other line-sharing answering devices (fax machine, answerphone, etc.).
NOTE
: All other line-sharing answering devices must be set to answer in-
coming calls after 2 or more rings.
Installer Code
---- type in the Installer Code.
With the exception of the
Tone check
option, the
Remote Communica-
tion
window initialises with preset parameters (programmed in other parts
of the application). Any changes made to the parameters in the
Remote
Communication
window will not affect the respective parameters in other
parts of the application.
5
. Click on
Dial
to start the communication ---- the communication status
will be shown at the bottom of the window. At this point, you can down-
load/upload to/from the connected control panel.
Successful communications will be confirmed by the following message:
Fireclass ACK01.00 CONNECTION
6
. Click on
OK
to close the
Remote Communication
window.
On hook
Click on
On hook
from the
Modem
menu to end the communication.
Figure 10
Remote Communication window
18
Analogue Fire Control Panels
FireClass
Summary of Contents for FireClass100
Page 1: ... SOFTWARE MANUAL ...
Page 34: ...34 Analogue Fire Control Panels FireClass ...
Page 47: ...Notes GMap 47 ...
