BENSHAW RSi H2P Series, Instruction Manual

Page: 14 / 47

890053-02-00
Page 10 of 40
6.3
Control Related Parameters
These parameters have different default settings for Lead/Lag control.
Control Related Parameters - Defaults for Lead Lag
Macro
Parameter
Original
Parameter
LCD Display Setting Range Default Unit
Data
share
NOTES
- IN-87 DI NC/NO Sel
0 0000 0000 – 1 1111 1111
0 0000 000 1
bit No
With first bit set to " 1 ", Drive is in Run Mode
when Powered Up. P1 terminal input for Fx
(Forward Run) is closed. If using separate
Start/Run command, set first bit back to "0".
0
A Terminal
(NO)
1
B Terminal
(NC)
- IN-90 DI Status
0 0000 0000 – 1 1111 1111
0 0000 000 1
View No Status reflects IN-87 settings.
0
Contact
(Off)
1
Contact
(On)
- ADV-09 Run Prevent
0 None
2
Rever
se
Prev
No Prevent Reverse Rotation.
1
Forward
Prev
2
Reverse
Prev
- ADV-10 Power- on Run
0 No
1 Yes No
Related to IN-87.
Yes - Drive will start on Power Up with active
start/run command.
No - Drive requires start/run command after
Power Up.
1 Yes
- ADV-11
Power- On
Delay
0.0 -6000.0 0.0 secs No
- PRT-08 RST Restart
Bit 00 – 11
11 bit No
Automatic Fault Resets - This is a 2-bit
representation.
00 = Off Off, Disable Auto Fault Resets.
11 = On On, Enable Auto Fault Resets.
Bit 0
Faults other
than LV trip
Bit 1
LV Trip
- PRT-09 Retry Number 0 – 10 3 - No Number of Auto Reset attempts.
- PRT-10 Retry Delay 0.1 – 600.0 (sec) 5.0 secs No Time between Auto Reset attempts.
- DRV-05 KDP H.O.A Lock
0 Locked
1
Unloc
ked
No Keypad buttons not locked out. 1 During Run
2 Unlocked
- OUT-30 Trip OutMode
bit 0000-1111 1 010
-
Any output relay (OUT-31 ~ OUT- 39) that is set to the “Trip”
function will change state with the Interlock function. To
disable the trip output relay for the Interlock function only,
set bit 3 to “0”. ( 0 010).
Bit 0
Low voltage
Bit 1
Any faults
other than
low voltage
Bit 2
Automatic
restart final
failure
Bit 3
Operate
with
Interlock
Trip